Audion MK2 Technické informace

Thank you for purchasing the PerfectWave DAC Mk II upgrade kit. The instructions that follow will assist you through the modications necessary to up

25. 26. The I2S cable is labeled with four acronyms. 27. 1.MCK (Blue) 2.BCK (Yellow)3.DAT (Red) 4.LRCK (White).28. These acronyms will correspond to

31. 32. The I2S cable is colour coded and will correspond to the colour code on the new MKll digital board I2S input coaxial sockets.Installing the ne

The rst step in the process of the Type A analog board is to connect the new Mark II digital Input board to the Type A analog board. To do this you

42. This photograph shows a correctly installed I2s coax cable.Move on to the nal assembly section next and bypass the Type B assembly section.Type B

47. Reconnect the original J10 and J11 ribbon cables so the assembly process between the two boards is now complete.48. Copper Tape. (see photograph o

52. Put the black washer on the RCA connecter followed by the gold nut.53. Place the 1.5” X 0.755 nylon washer over the outside of the double “D” nut

Place the DAC Mk II Label64. Peel the back from the DAC Mk II label and place it on the rear panel of your DAC in the location shown below. F

Checking System Information69. Turn the rear panel switch OFF and then ON again. Once the “INITIALIZING” screen appears, tap the center of the displa

Your Kit Should Include the Following2, 1A, Slow Blow Gold Fuses1, DAC Mark II Name Plate1, 1.5” X 0.75 Nylon Washer1, DAC Mk II FirmwareHardware imag

2, Pieces Copper Tape2, M2.5 Phillips Pan Head Metric Screws1, 4-24 X 3/8” Tapping Screw2, M3-0.5 X 6mm Phillips Pan Head Metric Screws4, 4-40 X 3/8”

1, White cleaning cloth

1, Upgrade manual 1, DAC II Input Board 1, PerfectWave Remote control II 1, 5/8” wrench 1, Wrist Strap

The I2S cablesType AType B

Remove the Top Cover1. Unplug your DAC from its power source and unplug the AC line cord from the rear panel of the DAC.2. Find or create a padded w

9. Unscrew the 4 pieces of all thread from the top cover bracket and set aside.10. Wiggle and pull the top cover ground wire from the grounding block

17. Using your thumb and index nger, carefully rock the J10 ribbon cable back and forth out of the header as shown right.18. Using the same m